Stomp Pad Placement: Plumeria, Hawaiian Chain, and Peak to Peak
By Dakine | Backpacks, Luggage, Surf, Snow, & Bike Gear Since ... | Published: 2026-11-02
Category: How-to Guides
A step-by-step guide to placing a snowboard stomp pad for secure one-foot riding, with tips for Plumeria Stomps, Hawaiian Chain Stomp, and Diamond Scraper Mat.
Quick answer
Place your stomp pad between your bindings, centered under your back foot when it's placed against the back binding for one-foot riding. Clean the board, test the position with your boot, then peel and stick.
Why placement matters for one-foot riding
When you ride the lift or skate around, your back foot is out of the binding and presses against the inside of the rear binding. The stomp pad needs to sit exactly where that boot lands so you get traction without shifting your weight. If the pad is too far forward, your heel hangs off; too far back, your toe catches the edge. The sweet spot is usually just in front of the rear binding, centered on the board's width.
Choose a pad that matches your boot and board
Stomp pads come in different shapes and materials. The Hawaiian Chain Stomp is a single molded EVA foam piece with a textured top, good for riders who want a simple, low-profile grip. The Plumeria Stomps come as four configurable pieces, so you can arrange them around your boot's contact points or create a custom pattern. The Diamond Scraper Mat adds a snow scraper bar, which helps clear ice from your boot sole before you step in. All three use 3M peel-and-stick adhesive, so installation is similar.
When to use a scraper mat instead of a standard stomp pad
If you often ride in wet, sticky snow that builds up on your boot, the Diamond Scraper Mat's scraper bar gives you a place to knock off snow before stepping into your binding. That can improve binding engagement and reduce ice buildup. For most riders, a standard stomp pad like the Hawaiian Chain or Plumeria is enough, but the scraper mat is a practical upgrade for icy or wet conditions.
How to install a stomp pad step by step
- Clean the board: Wipe the board with a damp cloth and let it dry completely. Avoid using solvents or oils, which can leave residue and weaken the adhesive. A clean, dry surface is essential for the 3M adhesive to bond properly.
- Mark your boot position: Stand on the board in your riding stance with your back foot against the rear binding. Use a pencil or tape to mark where the ball and heel of your boot contact the board. Marking first prevents misalignment and ensures the pad sits under your boot.
- Peel and stick: Remove the backing from the stomp pad and press it firmly onto the board at your marked position. For multi-piece pads like Plumeria Stomps, arrange the pieces before peeling to check spacing. Press down for 30 seconds, especially on edges, to ensure full contact.
- Test and adjust: Step on the pad with your boot to check traction and comfort. If it feels off, you can carefully peel it up and reposition while the adhesive is still fresh. Avoid repositioning after 24 hours, as the adhesive will have fully set.
Product facts
- Hawaiian Chain Stomp - Black: Molded lightweight EVA foam made from 100% recycled materials with 3M high-grade peel-and-stick adhesive. The foam is light and won't add bulk, and the 3M adhesive holds securely without slipping.
Hawaiian Chain Stomp - Black - Plumeria Stomps - Off White: Four configurable pieces made from 100% recycled EVA foam with 3M peel-and-stick adhesive. You can arrange the pieces to fit your boot's contact points or create a custom grip pattern.
Plumeria Stomps - Off White - Diamond Scraper Mat: Molded urethane (100% recycled TPU) with a snow scraper bar and 3M high-grade peel-and-stick adhesive. The scraper bar helps clear snow and ice from your boot sole before stepping into the binding.
